Kitronik Timed Drag Racer Module

Note:
This kit requires some soldering. The battery holder and motor both need to be soldered to the PCB, and the 10nF capacitor soldered to the motor.
This Kit is not supplied with batteries, batteries can obtained separately here.
Features:
Combine electronics and design in an engaging and fun hands-on classroom exercise.
Build the kit, design & make the chassis and wheels and test. Set up races to measure the effectiveness of the designs.
The timed drag race module features a push button, when pressed the attached motor runs for 5 seconds.
The board also features button expansion pads that allow for an external/remote push button.
Operating voltage of between 2.5V and 3.0V
Nominally draws 220mA when the motor is running
Typical battery life for 2 x AA is approx. 2000 button presses.
Minimal kit assembly required, solder the battery holder and motor to the board. The rest is all your chassis design.
Contents:
1 x Kitronik Timed Drag Racer Board, pre-built.
1 x Low torque flat DC motor.
1 x AA battery holder.
1 x Ceramic Capacitor 10nf.
1 x Motor Pulley.